3mm ICOPAL HYDROBIT V60 S30 SBS - Torch-On Underlay Roofing Felt - 1m x 10m roll

3mm ICOPAL HYDROBIT V60 S30 SBS is a torch-on weldable felt underlay based on a glass wool matrix with a double-sided coating of SBS modified asphalt with a mineral filler. The top side is covered with fine-grained mineral sprinkles, the bottom side is profiled and protected with plastic foil. The felt is produced according to the patented "QUICK PROFILE" SBS technology. The membrane's glass wool matrix ensures resistance to fire and high temperatures, as well as a stable and immobile underlay in multi-layer roof coverings, and is also highly resistant to mechanical damage and tearing. HYDROBIT V60 S30 SBS asphalt felt can provide protection for materials that are not fire-resistant, such as thermal insulation made of polystyrene.

CHARCTERISTICS

• The roofing felts produced using this technology are weldable felts, modified SBS, which use a unique technology of profiling the underside, weldable side of the felt and a new generation matrix. 
• The unique way of shaping the underside of the roofing felt allows for increasing the surface of heat transfer from the burner. 
• The special thin anti-adhesive foil burns quickly, thanks to which the heat from the burner through the profile system quickly accumulates on a larger surface of the asphalt than in the case of ordinary roofing felt.
• Can achieve much better parameters in terms of breaking strength and relative extensibility.
• The thickness of the modified asphalt on the outside of the roofing felt has also been increased, which significantly extends the life of the roofing felt and increases its waterproofing and resistance to UV radiation.
• Can be torch applied or mechanically fixed.
• Longer service life.
• Greater durability of the roof covering.
• Complete tightness of the roofing felt coating.
• Technical specification: EN 13707 + A2:2012 – Flexible waterproofing and asphalt-based products for roofing.

APPLICATION

• Roof waterproofing,
• Roof waterproofing subject to reaction to fire.

INSTALLATION

• The roofing felt should be laid at a temperature not lower than 0°C.
• The rolls must be properly prepared before laying: stored at a temperature of +15°C for at least 24 hours.
• Roofing felt should not be laid on wet roof surface, icing, during precipitation and strong wind.